Vinyl Click Flooring in Dallas-Fort Worth

Vinyl Click Flooring can be installed over an existing surface and refers to the actual installation method. These flooring products do not require ripping up the existing flooring, removal and disposal of flooring waste, or subfloor preparation. By relying on click-locking installation technology, vinyl click flooring does not use adhesive or nails since the tight connection and pressure between pieces keeps the entire surface in place! Click vinyl floors will be quicker and cheaper to install than other flooring types.

Installing vinyl click flooring will likely raise the overall flooring height in a room. This will require you to remove any base trim and molding during installation and reinstall it once the finished floor is down. You will most likely need to remove all doors and shave down the bottoms to achieve full range of motion when opening and closing your doors.

Over time, vinyl click flooring will prove to be easier to repair if a piece or section gets damaged: Simply take out the planks between the damaged pieces and the wall, and snap new flooring in place to restore the surface.

Very few flooring products can offer the DIY capability that vinyl flooring does. Vinyl click flooring offers far greater DIY opportunities for those with flooring installation experience. Take the proper time to gather tools, allow your planks to acclimate to the new environment for at least 48 hours beforehand, and always reference the manufacturer’s installation instructions to maintain your product warranties.